white-line

Hidden internal corner profile for sealing

line

Corner profile for joining

It’s very easy to install our wall panels. If DIY is not for you, you can hire a contractor. If they are not already a certified Fibo installer, you can ask them to read the instructions below. It’s an easy job for any contractor!

1. Start Installing Above Door.

  • 1 The profile is delivered pre-drilled, with the first hole 1.97 inches from the lower edge and subsequent c/c spacing of 11.8 inches.
  • 2 Install the corner profile at the back of the panel using a special screw as shown in the image (included with the corner profile).
  • 3 For Wet Room Zone 1, all panel edges should be joined using Fibo Seal or other sealant that is approved according to ETAG022.
1

2. Fit the internal corner profile

  • 1 to a stud or existing fixed wall using the pre-drilled and countersunk holes.
  • 2 Cut the next panel to the desired width, apply sealant to the newly cut area and fold the panel into the corner profile.
2

3. Adjust the joint between the panels and apply sealant

  • 1 (we recommend masking tape for the best result). Clean with Fibo Clean, Fibo Sealing Tool and Fibo Wipes
3

4. Finished!

4
small-line-white

Design & Inspiration

View our collections

small-line-white

Need Help Getting Started?

Follow our installation guide

small-line-white

Check Out Fibo Explorer

Design it yourself